Remington Hair Dryer D 3510is User Guide

CS27326_3510is_IB_update 6/28/05 9:58 AM Page 1  
Use and Care Guide  
D-3510is  
 
CS27326_3510is_IB_update 6/28/05 9:58 AM Page 4  
Safety Instructions  
1. Should the ALCI safety device trip (i.e.,  
the reset button pops out) during use,  
press the reset button. Should the hair  
dryer fail to reset, call 800-736-4648.  
Never operate this appliance if it has  
been dropped in water.  
ALCI Safety Device  
This hair dryer is provided with an  
appliance leakage circuit interrupter (ALCI)  
safety device built into the plug. This device  
is designed to make the unit inoperable  
under some abnormal conditions, such as  
accidental immersion in water. The ALCI  
safety device is equipped with a test button  
so that its operation can be checked.  
This unit should be tested before each use  
2. The dryer is designed to work on  
ordinary household current only, 125  
volts A.C., 60 Hz. It is not intended for  
commercial use.  
GROUND FAULT CIRCUIT  
INTERRUPTERS CAN  
SAVE A LIFE!  
to confirm that the safety device is  
operational.  
3. This appliance is equipped with an  
automatic thermal limiter, which will  
To test:  
cycle off when overheated and come  
After plugging in your hair dryer:  
back on when cooled down. If the unit  
If you must use your hair dryer in the  
cycles off, unplug the cord for several  
minutes before restarting.  
ALCI device.  
1. Press the reset button on the  
bathroom, install a GFCI* now!  
Your local electrician can help you decide which type is best for you –  
a portable unit that plugs into the electrical outlet or a permanent  
unit installed by your electrician. The National Electrical Code now  
requires GFCI’s in bathrooms, garages, and outdoor outlets of all  
new homes.  
4. This appliance has a polarized plug  
2. Press the test button. The reset button  
(one blade is wider than the other). As  
will pop out. This verifies that the safety  
a safety feature, this plug will fit in a  
device is operating properly.  
polarized outlet only one way. If the plug  
does not fit fully in the outlet, reverse the  
plug. If it still does not fit, contact a  
qualified electrician. Do not attempt to  
3. Press the reset button to reactivate your  
ALCI safety device.  
Why do you need a GFCI?  
Electricity and water don’t mix. If your hair dryer falls in water while  
it’s plugged in, the electric shock can kill you– even if the switch is  
off.” A regular fuse or circuit breaker won’t protect you under these  
circumstances. A GFCI offers you greater protection.  
defeat this safety feature.  
4. Your hair dryer is now ready for use.  
Note: This unit may automatically trip  
when unplugged. If so, the unit must be  
reset after it is plugged in. If the dryer  
doesnt reset after following the above  
testing procedure, call 800-736-4648.  
A GFCI can save your life!  
Compared to that, the price is small!  
Dont wait… install one now!  
*GFCI is a sensitive device that reacts immedi-  
ately to a small electric current leak by stopping  
the electricity flow.  
4
5
 
CS27326_3510is_IB_update 6/28/05 9:58 AM Page 6  
Product Features  
Thank you for purchasing the Remington® Protect & Shine™  
ionic hair dryer with 3X protection – the ultimate defense against damage.  
1875 watts  
Complete ion protection & control Remington ion control technology.  
Cool Shot  
Removable  
grille  
Air concentrator  
- /+  
Ion  
3 heat settings  
Switch  
OFF/LOW/HIGH  
speed settings  
Angled barrel for  
easy handling when  
drying the top of  
your head  
Cord with  
hang loop  
Ceramic Heat  
Ionic Conditioning  
Ceramic emits far-infrared,  
radiant heat to help dry  
water molecules inside the  
hair strand. This fast and  
efficient process helps  
prevent heat damage to  
the outer cuticle for less  
frizz and shine.  
Negative ions prevent static  
and frizz, giving hair a more  
healthy-looking shine.  
Slow-Moving  
Hot Air  
Fast Air  
High Speed  
Airflow  
A powerful fan design with a narrow  
barrel creates a high-speed airflow to  
help reduce hot spots and over-drying.  
6
7
 
CS27326_3510is_IB_update 6/28/05 9:58 AM Page 8  
How to Use  
Hair Care Tips  
To create a style with lots of body, apply  
Cool Shot:  
The Cool Shot sets the style by blowing a  
cool stream of air. Press and hold cool shot  
Basic Drying Techniques  
Hair Care Tips  
volumizing mousse to towel dried hair.  
Distribute it evenly from roots to ends,  
then blow dry as usual. Hair will be soft,  
shiny, and full of volume.  
1. Gently towel dry hair to remove excess  
Keep the dryer about 8 inches away  
from your head to avoid burning scalp or  
damaging hair.  
water. Avoid rubbing hair with towel –  
button to set style. Release button to return  
this creates split ends and frizziness.  
to warm air flow.  
Detangle hair with a wide-toothed comb.  
Always keep the dryer pointed down the  
hair shaft to smooth the cuticle and  
create a silky, shiny style.  
For a super smooth, salon-like blow dry,  
finish by running a straightening iron  
over dried hair.  
For straight, smooth hair:  
With the dryer turned off, attach the  
concentrator to the end of the nozzle. Brush  
2. Be sure dryer is turned off. Plug dryer  
into an electrical outlet.  
hair from underneath using a large, round  
brush or paddle brush. Pull hair down until  
3. Set dryer ion switch to negative (-)  
drying ion position. Turn the dryer on  
To help prevent heat damage and add  
shine, spritz damp hair with a heat  
protection spray before blow drying.  
For a quick touch-up between sham-  
poos, mist hair to dampen it, then style  
with dryer.  
the hair is fully extended and taut. Run the  
and set it to a high heat and speed.  
dryer slowly down the length of the hair  
Remove some of the additional moisture  
several times until dry. Repeat with all  
form your hair by briskly blowing it all  
sections of hair until it is completely dried.  
over, using your fingers to comb”  
Lock in the style with the Cool Shot.  
through hair.  
For curly hair:  
Use dryer on a low heat and speed setting  
4. When hair is almost dry, lower the heat  
and speed to the desired settings and  
and move it quickly about your head. As  
begin to style.  
you dry your hair, scrunch it with your  
favorite styling product or twirl strands of  
hair around your fingers to add definition.  
5. Set ion switch to positive (+) styling ion  
position. Divide hair into manageable  
When finished drying, lock in the style with  
sections. Begin at the nape of your neck  
the Cool Shot.  
and brush hair, following the movement  
of the brush with the dryer. Continue  
working your way up to your scalp, then  
to the sides and the front, drying small  
sections at a time.  
RECOMMENDED SETTINGS  
HAIR TYPE  
Airflow  
Heat  
Short and Curly  
Low  
Low  
Short and Sculptured  
Mid-Length and Sculptured  
Mid-Length and Sleek  
High  
Low  
6. Once your desired style is achieved, push  
the Cool Shot button to set the style with  
a cool flow of air.  
Low  
High  
Medium  
Medium  
High  
Mid-Length or Long and Curly Low  
Long and Sculptured  
Long and Sleek  
High  
High  
High  
High  
8
9
 
CS27326_3510is_IB_update 6/28/05 9:58 AM Page 10  
Warranty  
Cleaning and Maintenance  
Full Two-Year Warranty  
Spectrum Brands, Inc.  
Maintenance Instructions  
The dryer needs minimum maintenance to  
ensure the best performance and long life.  
Storage  
Spectrum Brands, Inc. warrants this product  
against any defects that are due to faulty  
material or workmanship for a two-year  
period from the original date of consumer  
purchase. This warranty does not include  
damage to the product resulting from  
accident or misuse.  
When not in use, unplug the unit. Allow it to  
cool, and store out of reach of children in a  
safe, dry location. Never wrap the cord  
around the appliance, as this will cause the  
cord to wear prematurely and break. Handle  
cord carefully, and avoid jerking, twisting, or  
straining it, especially at plug connections.  
Money-back Offer  
If within 30 days after you have purchased  
your Remington® branded product, you are  
not satisfied and would like a refund, return  
it with the sales slip indicating purchase  
price and date of purchase to the retailer  
from whom it was purchased. Spectrum  
Brands, Inc. will reimburse all retailers who  
accept the product within 30 days from the  
date of purchase. If you have any questions  
concerning the money-back guarantee,  
please call 800-736-4648.  
Keep all intake openings clear of dust  
accumulation. See Cleaning Instructions”  
below. No other maintenance or  
lubrication is required.  
If the product should become defective  
within the warranty period, we will repair it  
or elect to replace it free of charge. Please  
call 800-736-4648.  
If the cord becomes twisted due to use,  
periodically straighten it. Store appliance  
and cord where they will not be damaged.  
Do not wrap cord around dryer.  
125 VAC 60 Hz  
Do not attempt to repair the appliance  
yourself.  
SPECTRUM BRANDS, INC. SHALL  
NOT BE RESPONSIBLE FOR ANY  
INCIDENTAL, SPECIAL OR  
Questions or comments:  
Call 800-736-4648  
Cleaning Instructions  
The air filter should be cleaned regularly,  
since a dirty or clogged filter will impair the  
efficiency of the dryer.  
CONSEQUENTIAL DAMAGES.  
This warranty gives you specific legal rights  
and you may also have other rights which  
vary from state to state. Some states do not  
allow the exclusion or limitation  
of incidental, special, or consequential  
damages.  
REMINGTON and PROTECT&SHINE  
are trademarks of ROVCAL, INC.  
1. To clean air filter, make sure dryer is  
turned off and unplugged.  
©2005 ROVCAL, INC.  
06/05 Job# CS27326  
Spectrum Brands, Inc.  
800-736-4648  
T2207838  
2. Gently rotate the air inlet grille counter-  
clockwise while lifting the air filter away  
from the dryer.  
MADE IN CHINA  
This product is listed by  
Underwriters Laboratories, Inc.  
and bears the mark.  
3. Use a soft bristle brush to gently remove  
any particles that are lodged in filter.  
4. If the unit is dirty, wipe it with a damp  
cloth.  
5. To replace the air inlet after cleaning,  
align locking tabs and rotate clockwise  
to secure.  
10  
11  
 
CS27326_3510is_IB_update 6/28/05 9:58 AM Page 12  
 

Radio Shack Headphones 33 268 User Guide
Radio Shack Motorized Toy Car 60 4325 User Guide
RCA Car Satellite Radio System ANT711 User Guide
RCA TV DVD Combo 13R400TD User Guide
Royal Sovereign Laminator RSL 2701 User Guide
Samsung Camera Accessories SPD 3700T User Guide
Samsung Cell Phone 570DX User Guide
Samsung Laptop M55 User Guide
Samsung Printer 550 User Guide
Sears Range 91191461 User Guide